Solar Roofing

Looking into any Solar Roofing around Jefferson Hills Pennsylvania?

Get clear on whether your roof is ready to carry solar

Phone 412-858-8858 and tell us about the house

Start With the Roof, Not the Panels: What Gets Checked First

Solar Roofing begins with a hard look at the shingles, flashing and decking underneath; the decision between repair and replacement is made first, before layouts are drawn. The deck and framing carry the weight of the whole system; fasteners need solid wood to bite into, not a rotten board.

A roofer looking over a roof for solar notes the age, the layers and the condition of every slope; the findings sort the roof into sections that are sound and sections that are not. Find out whether leaks have appeared in the past and where; patterns of old trouble point to a detail that needs correcting.

A roof that is ready for solar is flat, sound and well flashed; each decision about the layout rests on what the roof can carry. Solar equipment is built to last for a very long time; a roof with plenty of good years left carries an array without trouble.

Sun, Shade and Slope on Hilly Ground: Chimneys, Dormers and Neighbors

Solar Roofing depends on which parts of the roof see sunlight for long stretches of the day; the path of the sun is lower in winter, so shade lengthens in the cold months. The Pittsburgh area has plenty of gray days, so honest expectations matter; trees that were small at planting have grown past the roofline.

Every slope gets its own check, since a house can have good and poor sections side by side; a low winter sun reaches a south slope even when the days are short.

Hip roofs and roofs with dormers break the surface into smaller sections; a roofer who knows the house suggests which slopes to use. A hillside to the south can shade a roof for a good part of the winter day; the neighbors' trees and buildings count as well as the owner's.

A plan that looks at the whole year gives a more honest picture; evergreen trees shade a roof all year, while bare trees let light through in winter.

Panels on Top or Tiles in the Roofline: How the Styles Differ

Another approach uses solar tiles or shingles that replace the roofing itself; a rack system leaves the existing roofing in place and adds a layer above it. Courses are set to lines so the rows stay straight and the water sheds correctly; slow, exact work is the rule because each piece depends on its neighbor.

Roofing-grade tiles and panels each have their own weight and thickness; a flat black panel looks different from one with silver frames.

Some look like ordinary shingles, and some look like clay or concrete tiles; the roofing material underneath decides which products can be used. Careful handling matters because the pieces are heavier and more delicate than shingles; replacement tiles are set aside so a damaged one can be swapped later.

Penetrations Done Right: Getting the Layers Right

Mounts for a rack system pass through the roofing and anchor in the framing; the mount is set into sealed layers so water flows around it and not under it. Slate and clay call for special brackets that grip without cracking the material; careful planning keeps the roof watertight under the array.

Mount spacing follows the layout so the load is spread through the framing; a mount that misses the rafter holds poorly and leaks.

A solar mount is a tiny roof repair waiting to be done well or badly; a mount sealed with care outlasts one sealed in a hurry.

Panels act like sails on a gusty day, so mounts are spaced and fastened for uplift; fasteners go into solid framing and are driven to the right depth. Flashing at each mount directs water around the post, not into the hole; clean gutters protect the fascia and the siding below.

Cold-Season Realities: Planning for Winter

Anyone planning Solar Roofing should ask how the array will handle a heavy snowfall; the area below the array deserves as much thought as the array itself. Edges and eaves need the same protection they have always needed; clearing debris from the gutters before winter prevents backups.

Cold snaps leave frost on panel glass that lets go in a sheet at the first thaw; clear paths to doors and steps matter more under a slick roof.

Fixing air leaks in the ceiling below is part of a complete plan; the eaves need the same barrier and the same attention they always did.

Who Does What on a Solar Job: Dividing the Work

Electricians handle the wiring, the inverter and the connection to the house; clear communication between the trades prevents holes in the wrong place. The two crews work in a sequence, and each depends on the other; a missed handoff costs days and can mean opening a finished area again.

Wire entries get the same care as any other opening in the roof; keeping the attic clean and dry helps both crews work safely.

The electrician needs a route from the array to the equipment in the house; the route avoids rafters, vents and spots where water collects.

Reroofing and Removing Panels: Avoiding a Second Tear-Off

Solar Roofing fits easily into a schedule that already has a reroof in it; the two projects share staging, scaffolding and access. Sometimes the roof needs work after the array is up; the electrical side must be shut down before anyone touches the panels.

Planning a reroof and solar together uses one set of access and staging; the owner sees the whole job laid out in one plan.

Solar adds a layer of care to every roof; birds and squirrels sometimes nest beneath panels, and that is worth watching.

Doing the roof first often means a single mobilization for the crew; the weather windows in the region are limited, so planning matters.

Watching the Roof Over the Years: Small Habits, Long Life

Panels do not retire a roof from regular care; staining on the ceiling below is a signal to call a roofer promptly. A soft brush or a gentle rinse from the ground keeps panels clear without scraping the glass; ice and snow are left to melt rather than chipped away.

The First Step Is a Roof Walk: A Call Away

A quick conversation now about the roof can make the plan stronger later; contact us at 412-858-8858 to start the conversation. Describe the house, the roof and your questions, and a roofer will take it from there; weather will not wait, and neither should the questions.

Charles Kotulsky

Verified

★★★★★
We used John and The Roofing Company to replace our roof before the summer. They showed us the Atlas shingles and we went with the hearthstone color. They removed the old roof and put the new one on all in one day which was great. We love how it looks and will be calling them for siding next year

michael Zawodni

Verified

★★★★★
Put a roof over our deck, very professional, kept jobsite clean everyday, and went above and beyond with quality and craftsmanship. Couldn't recommend this company more!! Best around.

Chris Juricich

Verified

★★★★★
The price was right, and most importantly our new roof looks beautiful. It was also delivered on-time and with great communication throughout.

Mark Lehner

Verified

★★★★★
The Roofing Company LLC is hands down the most knowledgeable and professional contractor I’ve worked with. Their team is incredibly attentive, responsive, and reliable—from the first call to the final inspection. What truly sets them apart is their deep understanding of not just roofing, but the entire construction industry. John is a true professional with years of hands-on experience and insight. His knowledge goes far beyond shingles and gutters—he understands this industry from the ground up, and it shows in every detail of the job. If you’re looking for a contractor who delivers quality, communicates clearly, and stands behind their work, look no further. The Roofing Company LLC is the real deal.

Michael Long

Verified

★★★★★
Attention to detail was great , very professional company